Time to self assess.
The quiz below will help you gauge the skill you have gained so far.
Before taking this quiz, make sure you have absorbed the following tutorial.
AutoCAD quiz
Quiz-summary
0 of 10 questions completed
Questions:
- 1
- 2
- 3
- 4
- 5
- 6
- 7
- 8
- 9
- 10
Information
Here comes the moment to test some knowledge you are meant to have acquire so far. Some questions might seem too math-like, but remember those are things you need to know.
You have already completed the quiz before. Hence you can not start it again.
Quiz is loading...
You must sign in or sign up to start the quiz.
You have to finish following quiz, to start this quiz:
Results
0 of 10 questions answered correctly
Your time:
Time has elapsed
You have reached 0 of 0 points, (0)
| Average score |
|
| Your score |
|
Categories
- Not categorized 0%
-
Hope you enjoyed this AutoCAD quiz. Go ahead and share your results with your friends
- 1
- 2
- 3
- 4
- 5
- 6
- 7
- 8
- 9
- 10
- Answered
- Review
-
Question 1 of 10
1. Question
What is the value of the angle B in the following figure?
Correct
Incorrect
-
Question 2 of 10
2. Question
To draw the 85 unit line shown on the following image in AutoCAD, what command line do we need?
Correct
Incorrect
-
Question 3 of 10
3. Question
On the trigonometric circle, 180 degrees correspond to
Correct
Incorrect
-
Question 4 of 10
4. Question
When was the first version of AutoCAD released?
Correct
Incorrect
-
Question 5 of 10
5. Question
If A has x and y coordinates equal to (10,50) and B equal to (25,50), What is the length of AB?
Correct
Incorrect
-
Question 6 of 10
6. Question
What does 2D means in the context of Computer Aided Design?
Correct
Incorrect
-
Question 7 of 10
7. Question
Can I draw in centimeter in AutoCAD?
Correct
Incorrect
-
Question 8 of 10
8. Question
One lap on the trigonometric circle is
Correct
Incorrect
-
Question 9 of 10
9. Question
If you were asked to draw the following image in AutoCAD, do you have all information to do it?
Correct
Incorrect
-
Question 10 of 10
10. Question
What is the primary file’s type used by AutoCAD?
Correct
Incorrect
2 comments
180º is the same thing as 0º and -180º, so I think that both should be acceptable.
180º is not the same as 0º.
180º is the same as -180º
and 0º is the same as 360º