In this challenge, we are going to be perfecting how to handle positioning and location in AutoCAD.
The Object SNAP mode will be important for this session, The exercise itself is an easy one, but you need to be a bit cautious while working on the project.
The use of the OFFSET command will be helpful and the ability to create a circle using the feature Tan, Tan, Radius.
Learning AutoCAD Basics
The following is the exercise we are going to be using in this session.
Figure 1
A piece of additional important information is indicated in the following picture.
Figure 2
Execution
The following is the key image that will help complete this project.
You need to first get the above image then Trim it, and you should get the following.
What you need to do now is: Give the red part an OFFSET of 10 units, and you will end up with the following.
It is all clear now, I imagine. You surely know what to do next to complete this. Do not forget the two FILLET of R5 located below the two circles.
16 comments
Thanks for your input